Kawasaki Brute Force 750 4x4i Offroad Vehicle User Manual


 
WHEELS/TIRES 11-13
Front Hub
Front Hub Removal
Remove:
Cap [A]
Cotter Pin [B] (cut)
Loosen the axle nut [C].
Remove the wheel (see Wheel Removal).
Remove the caliper by taking off the mounting bolts, and
let the caliper hang free.
Remove the axle nut [A] and pull off the front hub [B] and
brake disc.
Separate the brake disc from the front hub.
Front Hub Installation
Install the brake disc (see Brakes chapter).
Wipe dry the spline portion of the hub.
Wipe dry t he threads and seating surface of the nuts.
Install the front wheel temporary.
Tighten:
Torque - F ront Axle Nuts: 197 N·m (20 kgf·m, 145 ft·lb)
Remove the front wheel.
Insert a new cotter pin [A].
NOTE
When inserting the cotter pin, if the slots in the nut do
not align with the cotter pin hole in the axle shaft, tighten
the nut clockwise [B] up to next alignment.
It should be within 30 degree.
Loosen once and tighten again w hen the s lot goes past
the nearest hole.
Bend the cotter pin [A] over the nut.