Kawasaki Brute Force 750 4x4i Offroad Vehicle User Manual


 
FINAL DRIVE 12-15
Output Bevel Gears
Apply grease:
O-rings [A]
Install:
Output Drive Bevel Gear Cover [B]
Tighten:
Torque - Output Drive Bevel Gear Cover Bolts [C]: 8.8 N·m
(0.90 kgf·m, 78 in·lb)
Install:
Forward/Reverse Detecting Sensor [A]
Tighten:
Torque - Forward/Reverse Detecting Sensor Mounting
Bolt: 15 N·m (1.5 kgf·m, 11 ft·lb)
Output Drive Bevel Gear Disassembly
Remove:
Output Drive Bevel Gear Housing [A] (see Output Drive
Bevel Gear Removal)
Look through the hole [B] in the housing.
Turn the bevel gear [C] until the groove of the output drive
bevel gear holder nut is seen.
Tighten the nut holding bolts [A] (4) securely into the
grooves [B] of the bevel gear holder nut [C] in the output
drive bevel gear housing.
Special Tool - Nut Holding Bolts: 57001-1481
[D] Output Drive Bevel Gear Housing
[E] Outer Ball Bearing
[F] Inner Ball Bearing
[G] Bearing Holder
[H] Output D rive Bevel Gear