Filter
Top Products
10-10 CRA NKSHAF T/TRANSMISSION
Crankcase
•
Press and insert the new ball bearings until they are bot-
tomed.
Special Tool - Bearing Driver Set: 57001-1129
[A] Ball Bearing
[B] Ball Bearing (sealed side towards crankcase)
•
Press and insert the new needle bearings so that the
bearing surfaces are flush with the end of the hole.
[C] Needle Bearing
[D] Needle Bearing (Insert it from outside.)
•
Apply engine oil to the bearings.
•
Install:
Oil Pressure Relief Valve [E] (see Engine Lubrication
System chapter)
•
Install:
Rear Cylinder Camshaft Chain Guide [A]
•
Tighten:
Torque - Rear Cylinder Camshaft Chain Guide Bolt [B]: 20
N·m (2.0 kgf·m, 14 ft·lb)
•
Press and insert the new ball bearings [A] until they are
bottomed.
Special Tool - Bearing Driver Set: 57001-1129
•
Press and insert the new needle bearings so that the
bearing surfaces are flush with the end of the hole.
[B] Needle Bearing
[C] Needle Bearing (Insert it from outside.)
•
Apply engine oil to the bearings.
•
Install the ball bearing [A] so that the stepped side faces
outside [B].
•
Install:
Plates [C]
•
Apply a non-permanent locking agent to the bearing po-
sition plate screws [D].
•
Tighten:
Torque - Bearing Position Plate Screws: 4.9 N·m (0.50
kgf·m, 43 in·lb)