Filter
Top Products
FINAL DRIVE 12-41
Front Final Gear Case
•
Install:
Cam Lever [A]
Needle Bearing [B]
•
Apply engine oil to the needle bearing.
•
Check the wear of the disc assembly as follows.
○
Measure the thickness of the inner disc [A].
•
Select the width [A] of the disc assembly [B] in accordance
with the thickness of the inner disc, refer to the below
table.
Thickness of Inner
Disc Assembly
Width [A] of Disc Assembly
2.4 mm (0.0945 in.) 16.7 ∼ 17.3 mm (0.6675 ∼ 0.6811 in.)
1.8 mm (0.0709 in.) 17.31 ∼ 17.9 mm (0.6815 ∼ 0.7047 in.)
1.2 mm (0.0472 in.) 17.91 ∼ 18.5 mm (0.7051 ∼ 0.7283 in.)
○
Measure the width of the disc assembly at three locations,
and calculate average for three points.
NOTE
○
Be careful not to damage the facing surface [C] on the
outer plates.
If the width is within the specified range, install the inner
disc and disc assembly.
If the width is not within the specified range, replace the
disc assembly.
•
Install:
Inner Disc [A]
Disc Assembly [B] and Housing [C]