Kawasaki Brute Force 750 4x4i Offroad Vehicle User Manual


 
10-20 CRA NKSHAF T/TRANSMISSION
Transmission
Install:
Guide [A]
Tighten:
Torque - Shift Lever Assembly Bracket Bolts [B]: 20 N·m
(2.0 kgf·m, 14 ft·lb)
Set the lever assembly in the neutral position [ C] while
turning the tie-rod [D].
NOTE
Do not turn the shift shaft [E] when setting the lever
assembly on neutral position.
Turn the tie-rod until the rod [F] of the shift lever assembly
contact with the guide [G], and then the tie-rod can be
turned until 1/8. At that time, the clearance [H] which can
be made between the rod and the guide is 0 ~ –0.5 mm
(0 ~ –0.02 in.).
This clearance is a setting range for the neutral position.
Move the rod [F] to right and check it will be back to left
smoothly.
Tighten:
Torque - Tie-rod End Rear Locknut [I]: 9.8 N·m (1.0 kgf·m,
87 in·lb)
Holding the rear tie-rod end, and tighten the front locknut
[J].
Torque - Tie-rod End Front Locknut: 9.8 N·m (1.0 kgf·m, 87
in·lb)
NOTE
The front locknut has left-hand threads.
Do not lean the tie-rod rear end after tightening the front
locknut.
Right [K]
Wrong [L]
Check that the shift lever moves from right to left smoothly.
Install:
Spring [M]
Trim Seal [N]
Align the mark [O] of the grip [P] with the projection [Q] on
the guide.
Tighten:
Torque - Grip Hold Nut [R]: 9.8 N·m (1.0 kgf·m, 87 in·lb)