Filter
Top Products
6-14 CONVERTER SYSTEM
Drive Pulley
Drive Pulley Removal
•
Remove the t orque converter cover (see Torque Con-
verter Cover Rem oval).
•
Remove the three cover bolts [A] and install the drive pul-
ley holder [B].
Special Tool - Drive Pulley Holder: 57001-1520
•
Tighten the three cover bolts:
Torque - Drive Pulley Cover Bolts: 13 N·m (1.3 kgf·m, 113
in·lb)
•
Loosen the drive pulley bolt [C] (left-hand threads), hold-
ing the drive pulley with the drive pulley holder.
NOTE
○
The drive pulley bolt has left-hand threads. Turn the
wrench clockwise for loosening.
•
Remove the drive pulley bolt, two washers, and the
stepped washer, but do not remove the drive pulley
holder yet.
•
Remove the drive pulley [A] from the crankshaft by screw-
ing the drive pulley puller bolt [B] clockwise, while holding
the drive pulley with the drive pulley holder [C].
Special Tool - Drive Pulley Puller Bolt: 57001-1429
Drive Pulley Disassembly
•
Hold the drive & driven pulley holder (57001-1473) [A] and
the tapered guide of the holder (57001-1412) [B] in a vise
so that the upper s urface on the holder is 7 mm (0.28 in.)
[C] above the vise.
Special Tools - Drive & Driven Pu lley Holder: 57001-1473
Drive & Driven Pulley Holder: 57001-1412
•
Set the pulley onto the pulley holder.
•
Remove:
Drive Pulley Cover Bolts [A]
Drive Pulley Cover [B]