Filter
Top Products
17-72 ELECTRICAL SYSTEM
Actuator Control System
2WD/4WD Actuator Removal
•
Drain the front final gear case oil (see Front Final Gear
Case Oil Change in Periodic Maintenance chapter).
•
Remove:
Actuator Lead Connector [A]
Clamp [B]
•
Remove:
Actuator Mounting Bolts [A]
Actuator [B]
2WD/4WD Actuator Installation
•
When installing the pin [A], apply engine oil to the rod of
the actuator and install the collar [B] on the actuator and
then press the pin.
•
Apply grease to the O-ring [C].
•
Apply molybdenum disulfide grease to the collar.
•
Insert the collar into the groove [D] of the shifter so that
the long side [E] faces downward.
•
Apply a non-permanent locking agent to the actuator
mounting bolts, and tighten them following the tightening
sequence [1 ∼ 3].
Torque - 2WD/4WD Actuator Mounting Bolts: 9.8 N·m (1.0
kgf·m, 87 in·lb)
Engine Brake Actuator Removal
•
Confirm that the ignition switch is in OFF position.
•
Remove:
Torque Converter Cover (see Converter System chap-
ter)
Actuator Mounting Bolts [A]
Actuator [B]