Filter
Top Products
PERIODIC MAINTENANCE 2-37
Periodic Maintenance Procedures
Brake Light Switch Inspection
•
Turn on the i gnition switch.
•
Check the operation of the rear brake light switch by de-
pressing the brake pedal.
If it does not as specified, adjust the brake light timing.
Brake Light Timing
Standard: On after about 10 mm (0.4 in.) of pedal
travel [A]
Bra ke Light Timing Adjustment
•
Remove the right hootboard (see Frame chapter).
•
Adjust the brake light switch [A] up or down. To change
the switch position, turn the adjusting nut [B].
CAUTION
To avoid damaging the electrical connections in-
side the switch, be sure that the switch body does
not turn during adjustment.
Drive Belt Failure D etection System Inspection
•
Remove:
Seat (see Frame chapter)
•
Check the drive belt failure detection system according to
following chart.