Filter
Top Products
3-41
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
78-14092-01
Chapter 3 Configuring Devices
Using the Templates
Data Rates (Mb/sec)
1.0 From the list, select one of the following for
each of the four rates in megabits per second:
• basic—Allows transmission at this rate
for all packets, both unicast and
multicast. At least one data rate must be
set to basic.
• yes—Allows transmission at this rate for
unicast packets only.
• no—Does not allow transmission at this
rate.
2.0
5.5
11.0
Transmit Power From the list, select one of the following
milliwatt settings: 1, 5, 20, 30, 50, 100.
To reduce interference or to conserve power,
select a lower power setting.
Fragmentation Threshold
(256-2338)
Enter a setting to determine the size at which
packets are fragmented (sent as several
pieces instead of as one block).
Use a low setting in areas where
communication is poor or where there is a
great deal of radio interference.
RTS Threshold (0-2339) Enter a setting to determine the packet size at
which the access point issues a request to
send (RTS) before sending the packet.
A low RTS Threshold setting can be useful in
areas where many client devices are
associating with the access point, or in areas
where the clients are far apart and can detect
only the access point and not each other.
Table 3-10 Radio Hardware Settings (continued)
Field Description