2-13
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
78-14092-01
Chapter 2 Fault Monitoring
Specifying Policies
Specifying Policies
This is window allows you to activate or deactivate a set of pre-defined policies
for access points.
The policies you set in this window will determine how some of the faults are
displayed in the Faults > Display Faults subtab.
Note Your login determines whether you can use this option.
Procedure
Step 1 Select Faults > Specify Policies. The Access Point window appears.
Step 2 In the left pane, select the variable for which you want to set a policy.
• SSID—Go to Step 3
• Broadcast SSID Disabled—Go to Step 6
• WEP Enabled—Go to Step 6
• LEAP Enabled—Go to Step 6
• WEP Key Length—Go to Step 8
• HTTP Disabled—Go to Step 6
• Telnet Disabled—Go to Step 6
• User Manager Enforced—Go to Step 6
• HTTP Authentication—Go to Step 6
Step 3 To activate the policy, do the following:
Field Description
Verify Check if you want to verify that SSID is
enabled.
Polling Interval From the list, select the polling interval.