Filter
Top Products
7-5
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
78-14092-01
Chapter 7 Troubleshooting
Configure > Jobs The job failed. There are multiple
reasons a job may have
failed.
Make sure all the
bootstrapping steps have
been performed correctly on
the access point.
Check the jobvm.log by
selecting Administration >
Appliance > Status > View
Log File to further identify
and report the problem.
If after applying a
configuration template on
a device, the device
reboots, the job will be
categorized as Failed.
When applying a
configuration template on
a job with multiple
devices, if the job fails on
even one of the devices,
the job is categorized as
Failed.
Check if “Verification could
not be completed” appears
in the Job Run Detail > Job
Run Log to identify this
problem.
The job is reported
as failed, but the
configuration was
applied successfully
to the devices.
The SNMP timeout to the
device is too short.
Select Administration >
Discover > Device
Credentials > SNMP
Communities and increase
the SNMP timeout.
Feature Symptom Probable Cause Possible Solution