Filter
Top Products
Chapter 2 Fault Monitoring
Specifying Fault Thresholds
2-12
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
78-14092-01
Setting LEAP Server Response Time
Using this option, you can set up a threshold for LEAP server response time.
When the threshold is exceeded, a fault is generated and can be viewed under
Faults > Display Faults.
Procedure
Step 1 Select Faults > Specify Fault Threshold. The LEAP Server:Response Time
threshold window appears.
Step 2 Select LEAP in the left pane and the menu expands.
Step 3 Complete the following:
Step 4 Click Reset to refresh any fields you have changed but want to restore, or Apply
to set the new entries.
Field Description
Enable Check to enable a threshold for this component.
Polling Interval From the list, select the polling interval.
Settings
Overloaded From the list, select the severity level, the
response time, and the number of polling cycles
before the status is Overloaded.
Degraded From the list, select the severity level, the
response time, and the number of polling cycles
before the status is Degraded.
OK From the list, select the severity level, the
response time, and the number of polling cycles
before the status is OK.