Filter
Top Products
5-49
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
78-14092-01
Chapter 5 Performing Administrative Tasks
Managing the Appliance
Disabling or Enabling Telnet and Selecting SSH
Telnet is used for connecting to the Wireless LAN Solution Engine through the
CLI. By default, Telnet is enabled. To prevent unsecure connections through the
CLI, you can disable Telnet.
SSH provides a secure Telnet connection, encrypting all traffic, including
passwords. By default, both SSH1 and SSH2 are used.
Procedure
Step 1 Select Administration > Appliance > Security > SSH and Telnet. The SSH and
Telnet control panel appears.
Step 2 To change the type of SSH used, select the desired SSH version from Select
Protocol, then click Change Protocol.
Step 3 To enable or disable Telnet, make a selection from Telnet, then click Configure.
Changes takes place immediately.
Related Topic
Overview: Security, page 5-45
Viewing the Last 10 Logged-On Users
You can view information about the last 10 users who have logged on to
the WLSE.
Procedure
Step 1 Select Administration > Appliance > Security > Last 10 Logins.
The Last 10 Logins table appears, showing the following information for the last
10 logins.