Filter
Top Products
B-19
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
78-14092-01
Appendix B Command Reference
Privilege Level 15 Commands
Usage guidelines
To set the configuration for all backup and restore operations, use the backup
command.
Example
The following command will configure the backup and restore operations to
backup to and restore from host 209.165.200.224, set the username to user1, and
set the password to pass:
backupconfig 209.165.200.224 user1 pass
The following command clears all backup and restore configuration information:
no backupconfig
Related Commands
backup
listbackup
restore
show backupconfig
cdp
Use the cdp command to configure the Cisco Discovery Protocol
cdp {run [port] | timer seconds | holdtime seconds}
no cdp {run [port] | timer | holdtime}
Syntax Description
run start cdp
timer set cdp packets retransmission time.
holdtime set cdp packet info hold time.
port Ethernet port on which CDP will be enabled. Acceptable
values are eth0-15.