Filter
Top Products
Chapter 3 Configuring Devices
Using the Templates
3-14
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
78-14092-01
Deleting Ethertype Filters
Procedure
Step 1 To delete protocol filters for the access point's Ethernet port, select the set name
from the Current Ethertype Filters list, then click Delete.
Step 2 Select one of the following:
• Preview to see your changes before you apply them. (See Previewing the
Template, page 3-89.)
• Finish to save the template. (See Finishing the Template, page 3-89.)
• Another template category to configure more options. (See Template
Categories, page 3-2.)
Creating Special Cases
Procedure
Step 1 Select the default filter for which you want to define a special case.
Step 2 Enter the following:
Table 3-4 Ethertype Filter Special Cases Settings
Field Description
Special Cases
Ethertype Enter the Ethertype filter name.
Disposition From the list, select one of the following:
• Default—Use the disposition you set for the Ethertype
filter.
• Forward—Use this setting to forward protocol traffic.
• Block—Use this setting to block protocol traffic.