Filter
Top Products
Chapter 3 Configuring Devices
Using the Templates
3-66
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
78-14092-01
Step 2 Complete the following:
Note Clicking Clear removes all the current entries in the window and any
entries you have made in other Template windows up until that point.
Step 3 Select one of the following in the left pane:
• Preview to see your changes before you apply them. (See Previewing the
Template, page 3-89.)
• Finish to save the template. (See Finishing the Template, page 3-89.)
• Another template category to configure more options. (See Template
Categories, page 3-2.)
Field Description
Hot Standby Mode From the list, select one of the following:
• Enable—Use this setting to allow hot standby
mode.
• Disable—Use this setting to disable hot
standby mode.
Service Set ID (SSID) Enter the monitored access point’s SSID.
MAC Address for the
Monitored AP
Enter the monitored access point’s MAC address.
Polling Frequency (1-30) Enter the number of seconds between each query
the standby access point sends to the monitored
access point.
Timeout for Each Polling
(1-600)
Enter the number of seconds the standby access
point should wait for a response from the
monitored access point before it assumes that the
monitored access point has malfunctioned.