Filter
Top Products
1-3
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
78-14092-01
Chapter 1 Getting Started with the Wireless LAN Solution Engine
Getting Started
The WLSE’s system time is Universal Coordinated Time (UTC), and UTC is used
in certain displays, such as the Discovery Run Log. To display or reset the system
time, see the instructions in the Hardware Installation and Configuration Guide
for the CiscoWorks 1105 Wireless LAN Solution Engine.
Getting Started
Before you can use WLSE monitoring, configuration, and reporting, you must set
up your devices, initiate discovery, and move devices into the managed state. To
get started, follow the directions in the Quick Start Guide or use the following
task list.
Task Description and References
1. Set up devices (access points,
bridges, routers, switches, and LEAP
servers).
See Set Up Devices, page 5-4 for details.
2. Log in to the WLSE using a Web
browser.
Enter the WLSE’s IP address, followed by:1741; for
example, http://209.165.202.128:1741.
3. Enter device credentials. Device community strings must be entered on the
WLSE. See Setting Device Credentials, page 5-17.
For access point configuration tasks, the HTTP
username and password must be entered on the WLSE.
See Specify the HTTP Username and Password,
page 5-20.
4. Initiate discovery from the WLSE
or import devices from a file or from
CiscoWorks.
If you are using discovery from the WLSE, add seed
devices and enable discovery. You can initiate an
immediate one-time discovery or schedule discovery for
a later time. See Managing Device Discovery, page 5-2.
5. Verify the discovery. On the WLSE, verify that devices were discovered. See
View Discovery History and Status, page 5-12.