Filter
Top Products
Appendix B Command Reference
Privilege Level 15 Commands
B-38
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
78-14092-01
In this case, the ntp server command is entered into the system
configuration, but NTP will not function. Follow these steps to remove the
command and configure NTP correctly:
Step 1 Remove the ntp server command from the configuration by entering the no form
of the command. For example:
no ntp server ip-address
where ip-address is the IP address of the NTP server.
Step 2 Set the system clock to a time that is behind the time on the NTP server using the
clock set command. For more information about the clock command, refer to the
“clock” section on page B-20.
Step 3 Enter the ntp server command again to configure the NTP server on the system.
For example:
ntp server ip-address
Example
This command configures the system to use an NTP server:
ntp server 209.165.201.0
This command configures the system to stop using the NTP server:
no ntp server 209.165.201.0
Related Commands
clock