Filter
Top Products
Chapter7 Troubleshooting
7-4
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
78-14092-01
Configure > Jobs HTTP job does not
run or fails.
The credentials are not set
properly.
Make sure the credentials on
the WLSE are the same as
the credentials on the access
point or bridge using
Administration > Discover
> Device Credentials.
Make sure the credentials on
the access point or bridge
have firmware rights.
The TFTP server is not
set up correctly.
The TFTP setting on the
access point should point to
the WLSE as its TFTP
server. This can be done by
applying a template
configuration, containing
TFTP server settings,
through an SNMP job (only
11.08T and higher)
The device is not
responding to HTTP
jobs.
HTTP browsing is
disabled on the AP
because of this job run.
At the access point console,
turn on non-console
browsing, or schedule an
SNMP job for the device if
its version is11.08T or
higher.
SNMP job does not
run or fails.
The community string is
not set properly.
Make sure the SNMP
community string set on the
WLSE is the same as the
string set on the access point
or bridge using
Administration > Discover
> Device Credentials.
Make sure the SNMP
community string on the
access point or bridge has
firmware rights.
Feature Symptom Probable Cause Possible Solution