Filter
Top Products
B-23
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
78-14092-01
Appendix B Command Reference
Privilege Level 15 Commands
Usage Guidelines
Use this command to erase the configuration in Flash memory and reload the
device.
When you enter the command, you are prompted for confirmation. Enter yes to
confirm, or press Enter to accept the default response no.
Caution When you confirm this command, the system configuration is erased and the
system reboots automatically. The system will not operate until you
reconfigure it.
When the system reboots, you must reconfigure it with the setup program. For
information about using the setup program, refer to the Installation and
Configuration Guide for the Cisco 1105 Wireless LAN Solution Engine.
Example
This command erases the system configuration:
erase config
This will erase your configuration, return device t
o factory defaults, and reload the device
Do you want to continue?[no]:yes
firewall
To implement port filtering on the WLSE, use the firewall command.
firewall eth <0-5> [public | private] | [icmp telnet ssh snmp https 1741]
Syntax Description
eth <0-5> Port to be configured. Acceptable values are eth0-5.
public Denies access via ICMP, Telnet, SNMP, and the HTTP 1741
port.
private Denies no access.
icmp Denies Internet Control Message Protocol (ICMP) ping
messages.