Filter
Top Products
5-7
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
78-14092-01
Chapter 5 Performing Administrative Tasks
Using Discovery and Managing Devices
Routers and Switches
Note Only routers and switches that have properly configured access points or
bridges attached to them will be discovered.
On each router and switch, configure the following:
Task Procedure Notes
1. Enable CDP
and verify that
access points and
bridges are
visible from the
router or switch.
1. Enter enable mode.
2. Verify that CDP is running on the switch or
router:
On IOS-based devices, use the show cdp run
command.
On Hybrid OS-based Catalyst switches, use the
show cdp command
3. If CDP is not running, use the set cdp enable
command to enable CDP.
4. To verify that access points or bridges are
visible in the device’s CDP table, use the show
cdp neighbors command.
CDP is required for the
WLSE to discover the
device.