Filter
Top Products
Chapter7 Troubleshooting
7-2
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
78-14092-01
Faults
Configure
Feature Symptom Probable Cause Possible Solution
Faults > Display
Faults
The Display Fault
view is blank.
There are no faults to
report based on the
filtering criteria you
entered.
Not applicable.
Faults > Fault
Forwarding
Email fails to arrive
at destination.
The SMTP server is not
configured properly.
Configure the SMTP server
using the mailroute
command.
For information on the
mailroute command, select
Help > View PDF, then select
the Command Reference
appendix.
Feature Symptom Probable Cause Possible Solution
Configure >
Templates
The access point is
inaccessible
through the HTTP
port set through
template
configuration job.
The HTTP port setting
does not take effect until
the access point is cold
rebooted.
Cold reboot the access point.
Template
configuration job
fails every time.
The access point is not set
up properly.
Make sure the WLSE is
configured as a TFTP server
for the access point.
For additional information,
see Getting Started,
page 1-3.
Configure > Jobs The Undo function
does not work.
Your job is SNMP-based,
which is not supported by
the Undo function.
None.