Filter
Top Products
3-44
ENGINE
CLUTCH SLEEVE HUB/PRIMARY DRIVEN GEAR ASSEMBLY
• Inspect the slot of the clutch sleeve hub and primary driven
gear assembly for damage or wear caused by the clutch
plates. If necessary, replace it with a new one.
OIL PUMP
INSPECTION
• Rotate the oil pump by hand and check that it moves
smoothly.
• If it does not move smoothly, replace the oil pump assembly.
!CAUTIONI
* Do not attempt to disassemble the oil pump assembly.
* The
oil
pump
is available
only
as an assembly.
STARTER CLUTCH
INSPECTION
• Install the starter driven gear onto the starter clutch.
• Turn the starter driven gear by hand.
• Inspect the starter clutch for a smooth movement.
• Inspect that the gear turns one direction only.
• If a large resistance is felt for rotation, inspect the starter
clutch bearing or the starter clutch contacting surface on the
starter driven gear for wear and damage.
• If they are found to be damaged, replace them with new ones.
GENERATOR
INSPECTION (c:::::r9-9)
REASSEMBLY
• When installing the generator stator set bolts, tighten them to
the specified torque.
~
Generator
stator
set
bolt: 10 N·m (1.0 kgf-m, 7.0 Ib-ft)
NOTE:
Be sure to install the
grommet
to the generator cover.