Filter
Top Products
CHASSIS
8-77
• Adjust the drive chain, after connecting it. (c:::::r2-22)
• Stake the joint pin by turning (approximately 7/8 turn) the
pressure bolt "A"
@ with the bar until the pin end diameter
becomes the specified dimension.
_ Pin
end
diameter
specification
©
*
After
joining
of
the
chain
has
been
completed,
check
to
make
sure
that
the
link
is
smooth
and
no
abnormal
condition
is
found.
*
Should
any
abnormal
condition
be
found,
reassem-
ble
the
chain
link
using
the
new
joint
parts.
5.50 - 5.75 mm (0.217 - 0.226 in)DID
I
CAUTION
I