Filter
Top Products
• Place the drive chain link being disjointed on the holder part
@ of the tool.
• Turn in both the adjuster bolt
@ and pressure bolt "A" @ so
that each of their end hole fits over the chain joint pin properly.
• Tighten the pressure bolt "A"
@ with the bar.
• Turn in the pressure bolt "B"
@ with the bar @ and force out
the drive chain joint pin
®.
[CAUTION I
Continue
turning
in
the
pressure
bolt
"8"
@ until the
joint
pin has been completely pushed
out
of
the
chain.
NOTE:
After the joint pin ® is removed, loosen the pressure bolt
"8"
@
and
then pressure bolt ':A"@.
• Remove the joint pin ® of the other side of joint plate.
ICAUTION I
Never reuse
joint
pins, O-rings and plates. After
joint
pins, O-rings and plates have been removed from
the
drive chain,
the
removed
joint
pins, O-rings and plates
should
be discarded and new
joint
plate, O-rings and
plate
must
be installed.
DRIVE CHAIN CONNECTING
JOINT PLATE INSTALLATION
• Set up the special tool as shown in the illustration.
CD
Tool body @ Adjuster bolt
~
Grip handle (without hole)
@ Joint plate holder @ Pressure bolt "A"
(engraved mark
"F50") ({) Bar
@ Wedge holder & wedge pin
• Connect both ends of the drive chain with the joint pin
@
inserted from the wheel side ® as installed on the motorcycle.
® O-ring ... 4 pcs
@ Joint plate
Joint set part number
DID:
27620-40FOO
A WARNING
Do
not
use
joint
clip
type of drive chain. The
joint
clip
may have a chance to
drop
which may cause severe
damage to motorcycle and severe injury.
CHASSIS
8·75