Filter
Top Products
8·56
CHASSIS
BRAKE PAD REPLACEMENT
• Remove the pad mounting pins
CD
and springs.
• Remove the brake pads.
I
CAUTION
I
* Do
not
operate
the
brake
lever
while
dismounting
the
pads.
* Replace
the
brake
pads
as a set,
otherwise
braking
performance
will be
adversely
affected.
~®
»®
• Install the new brake pads.
~
Pad
mounting
pin:
16 N·m (1.6 kgf-m,
11.5Ib-ft)
NOTE:
* Before installing the pad, clean the piston
and
peel
the back-
ing sheet
~
from the pad.
* Pay attention to the direction of the convex
part
® of
pad
springs.
*
After
replacing the brake pads, pump the brake lever a few
times to check for proper brake operation
and
then check the
brake fluid level.
BRAKE FLUID REPLACEMENT
• Place the motorcycle on a level surface and keep the handle-
bars straight.
• Remove the brake fluid reservoir cap and diaphragm.
• Drain the old brake fluid as much as possible.
• Fill the reservoir with new brake fluid.
• Connect a clear hose to the caliper air bleeder valve and
insert the other end of hose into a receptacle.
• Loosen the air bleeder valve and pump the brake lever until
old brake fluid flows out of the bleeder system.
• Close the caliper air bleeder valve and disconnect a clear
hose. Fill the reservoir with new fluid to the upper mark of the
reservoir.
ill
Specification
and
Classification:
DOT 4
I
CAUTION
I
[ Bleed
air
from
the
brake
system.
(L:T2-27)