Filter
Top Products
• In this condition, check the "rim line" @ cast on the tire side
walls. The line must be equidistant from the wheel rim all
around. If the distance between the rim line and wheel rim
varies, this indicates that the bead is not properly seated. If
this is the case, deflate the tire completely and unseat the
bead for both sides. Coat the bead with lubricant and fit the
tire again.
• When the bead has been fitted properly, adjust the pressure
to specification.
• As necessary, adjust the tire balance.
ICAUTION
I
Do
not
run with a repaired
tire
at a high speed.
~
Cold inflation
tire
pressure
Front
Rear
Solo riding
250 kPa (2.50 kgf/
290 kPa (2.90 kgf/
cm
2
,
36 psi) cm
2
,
42 psi)
Dual riding
250 kPa (2.50 kgf/ 290 kPa (2.90 kgf/
crn-, 36 psi)
cm
2
,
42 psi)
BALANCER WEIGHT INSTALLATION
• When installing the balancer weights to the wheel, set the two
balancer weights
® on both sides of wheel rim.
jCAUTIONI
W~ight
difference between
the
two
balancer weights
must
be less than 10 g (0.02 Ib).
CHASSIS
8·73