Filter
Top Products
• Remove the dust seal with the special tool.
S 09913-50121: Oil seal remover
I
CAUTION
I
The removed
dust
seal
must
be replaced with a new
one.
INSPECTION AND DISASSEMBLY
TIRE INSPECTION (c::::r2-2S, S-70)
WHEEL INSPECTION (c::::rS-70)
REAR AXLE
Using a dial gauge, check the rear axle for runout.
If the runout exceeds the limit, replace the rear axle.
_ Axle shaft runout: Service Limit: 0.25 mm (0.010 in)
.KiOti
09900-20607: Dial gauge (1/100 mm)
09900-20701: Magnetic stand
09900-21304: V-block set (100 mm)
WHEEL DAMPER
Inspect the damper for wear and damage.
Replace the damper if there is anything unusual.
SPROCKET
Inspect the sprocket teeth for wear. If they are worn as shown,
replace the two sprockets and drive chain as a set.
CHASSIS
8·35
Normal wear
Excessive wear