Filter
Top Products
• Apply SUZUKI BOND to the mating surface of the middle
crankcase.
~99104-31140:
SUZUKI BOND "1207B" (USA)
II(iffiJ
99000-31110: SUZUKI BOND "1215" (Others)
NOTE:
Use
of
SUZUKI BOND is as follows:
* Make surfaces free from moisture, oil, dust
and
other foreign
materials.
* Spread on surfaces thinly to form an even layer,
and
assemble
the crankcases within few minutes.
* Take extreme care
not
to apply
any
BOND to the oil hole, oil
groove
and
bearing.
*
Apply
to distorted surfaces as it forms a comparatively thick
film.
ENGINE
3-77
• Tighten the crankcase bolt (9 mm) in ascending order of num-
bers assigned to these bolts. Tighten each bolt a little at a
time to equalize the pressure in the following two steps.
~
Crankcase bolt: (M9)
initial:
18 N·m (1.8 kgf-m, 13.0 Ib-ft)
Final:
50
0