Filter
Top Products
• Remove the bearing caps and measure the width of the com-
pressed plastigauge using the envelope scale. This measure-
ment should be taken at the widest part of the compressed
plastigauge.
_ Conrod big end oil clearance:
Standard: 0.032 - 0.056 mm (0.0013 - 0.0022 in)
Service Limit: 0.080 mm (0.0031 in)
• If the oil clearance exceeds the service limit, select the speci-
fied bearings from the bearing selection table.
• Check the corresponding conrod I.D. code number ("1" or "2")
®.
• Check the corresponding crank pin O.D. code number ("1",
"2" or "3") ®.
_ Bearing selection table
Crank pin
0.0.
®
Code 1 2
3
Conrod
1 Green Black Brown
1.0 ®
2
Black Brown Yellow
_ Conrod 1.0.
Code 1.0. specification
1
38.000 - 38.008 mm
(1.4961 - 1.4964 in)
2
38.008 - 38.016 mm
(1.4964 - 1.4967 in)
ENGINE
3·65