Filter
Top Products
4·8
FI
SYSTEM
DIAGNOSIS
USING TESTERS
• Use the Suzuki multi-circuit tester set (09990-25008).
• Use well-charged batteries in the tester.
• Be sure to set the tester to the correct testing range.
USING THE TESTER
• Incorrectly connecting the
CB
and 8 probes may cause the
inside of the tester to burnout.
• If the voltage and current are not known, make measure-
ments using the highest range.
• When measuring the resistance with the multi-circuit tester,
00
will be shown as 10.00 MQ and "1" flashes in the display.
• Check that no voltage is applied before making the measure-
ment. If voltage is applied the tester may be damaged.
• After using the tester, turn the power off.
,mitt
09900-25008:
Multi-circuit
tester
set
NOTE:
* When connecting the multi-circuit tester, use the needle
pointed probe to the back side of the lead wire coupler and
connect the probes
of
tester to them.
* Use the needle pointed probe to prevent the rubber
of
the
water proofcoupler from damage.
,rooh
09900-25009: Needle
pointed
probe
set
MULTI-CIRCUIT TESTER
o
oog
~
. ,
;
•
.'?.
',4
._
::...
~
~r-l
.-n~·
:lOA:-COII
...