Filter
Top Products
8·20
CHASSIS
FRONT FORK INNER ROD
LOCKNUT
• Adjust the height
(8)
of the inner rod threads by turning the
lock-nut
CD
as shown in illustration.
(8):
11 mm (0.43 in)
FORK SPRING
• Install the fork spring as shown in the illustration.
~
Upper side
I I
I
~
Lower side
• Install the adjuster rod
CD,
spring
(2),
spring retainer @ and
spacer@.
FRONT FORK CAP BOLT
• Pull up the inner rod with the special tool
®.
• Compress the spring with the special tool @ and then insert
the special tool
© between the lock-nut and the spacer.
iKidt,
09940-50120: Inner rod
holder
®
09940-94930: Front
fork
spacer holder @
09940-94922: Stopper plate ©
etI®
f1:iI
~~QI©
~LetI@
~
• Make sure that the height
(8)
of the inner rod threads is as fol-
lows.
(8):
11 mm (0.43 in)
• Slowly turn the cap bolt completely by hand until the end of
the cap bolt seats on the lock nut.
jCAUTIONI
Make sure
that
the rebound
damping
force adjuster
CD
to the
softest
position
before installing the cap bolt.