Suzuki GSX-R1000 Automobile User Manual


 
GENERAL
INFORMATION
1·3
!CAUTIONI
* If parts replacement is necessary, replace the parts
with
Suzuki Genuine Parts or their equiva-
lent.
* When removing parts that are to be reused, keep them arranged in an orderly manner so that
they
may be reinstalled in the proper order and orientation.
* Be sure to use special
tools
when instructed.
* Make sure that all parts used in reassembly are clean. Lubricate them when specified.
* Use the specified lubricant, bond, or sealant.
* When removing
the
battery,
disconnect
the
negative cable
first
and then the positive cable.
* When reconnecting the battery, connect
the
positive cable
first
and then the negative cable,
and replace the terminal cover on
the
positive terminal.
* When performing service to electrical parts, if the service procedures
not
require use
of
bat-
tery power,
disconnect
the negative cable the battery.
* When tightening the
cylinder
head and case
bolts
and nuts, tighten the larger sizes first.
Always tighten the
bolts
and nuts diagonally from
the
inside toward outside and to the speci-
fied tightening torque.
* Whenever you remove oil seals, gaskets, packing, O-rings,
locking
washers, self-locking
nuts, cotter pins,
circlips
and certain other parts as specified, be sure to replace them with
new ones. Also, before installing these new parts, be sure to remove any left over material
from the mating surfaces.
* Never reuse a circlip. When installing a new circlip, take care
not
to expand the end gap larger
than required to
slip
the
circlip
over the shaft. After installing a circlip, always ensure that it is
completely seated in its groove and securely fitted.
* Use a torque wrench to tighten fasteners to the specified torque. Wipe
off
grease and oil if a
thread is smeared with them.
After reassembling, check parts
for
tightness and
proper
operation.
* To protect the environment, do
not
unlawfully
dispose
of used
motor
oil, engine
coolant
and
other fluids: batteries, and tires.
To protect Earth's natural resources, properly dispose of used
motorcycle
and parts.