Filter
Top Products
r
• Install the starter clutch cover and tighten its bolt as shown.
NOTE:
* Fit the wire clamp to the starter clutch cover bolt ® as shown.
* Fit the
new
gasket washer to the starter clutch cover bolt @ as
shown.
ICAUTION I
Use
the
new gasket washer to prevent oil leakage.
(!J Starter idle gear
cover
bolt: 10 N·m (1.0 kgf-m, 7.0 Ib-ft)
• Install the starter idle
gear
NO.1
shaft @, starter idle gear
NO.1
({), washer @, thrust washer @, bearing @ and concaved
washer@.
• Install the dowel pins © and the new gasket ®.
ICAUTION I
I Use a new gasket
to
prevent oil leakage.
• Install the starter idle gear cover and tighten its bolts to the
specified torque.
(!J Starter idle gear
cover
bolt: 10 N·m (1.0 kgf-m, 7.0 Ib-ft)
NOTE:
Fit the gasket washer to the bolt ©.
ENGINE
3·89
GEARSHIFT SYSTEM
• Install the gearshift cam stopper
CD,
its bolt
~,
washer @ and
return spring
@.
NOTE:
Apply a small quantity
of
THREAD
LOCK
to the gearshift cam
stopper bolt
~
and
tighten it to the specified torque.
~
99000-32050: THREAD LOCK "1342"
(!J Gearshift cam
stopper
bolt: 10 N·m (1.0 kgf-m, 7.0 Ib-ft)