Filter
Top Products
6·8
EXHAUST
SYSTEM
• Connect the
NO.1
cable and
NO.2
cable to the EXCVA pulley.
(t:76-5)
• After connecting the
NO.2
cable @, loosen the lock-nut ® and
turn the adjuster
@ in or out until 11 - 12 mm (0.43 - 0.47 in)
of the thread length
CQl
on the cable adjuster cam be provided
and tighten the lock-nut
®.
• Check the EXCVA to adjustment position.
(t:76-4)
ICAUTION I
Do
not
use the adjustable wrench to turn EXCVA pul-
ley so as
not
to cause damage to the internal gear of
EXCVA.
• Install the pulley ® to the shaft @.
NOTE:
Make sure that the shaft's line
~
and
cable slots ® facing
upward
as shown.
• Hold the EXCVA pulley with an adjustable wrench, and then
tighten the pulley mounting bolt to the specified torque.
~
EXCVA pulley mounting bolt: 5 N·m (0.5 kgf-m,
3.7Ib-ft)
ICAUTION I
When loosening or tightening the pulley bolt, be sure
to fix the pulley with an adjustable wrench, or EXCVA
may get damaged.
ICAUTION I
The cable
slots
of the EXCVA pulley
must
be located
upward (adjustment position).
(t:76-4)
bCbo
:;===1
1
@ ®