Filter
Top Products
MASTER CYLINDER INSPECTION
CYLINDER, PISTON AND CUP SET
Inspect the cylinder bore wall for any scratches or other dam-
age.
Inspect the cup set and each rubber part for damage.
MASTER CYLINDER REASSEMBLY AND
REMOUNTING
Reassemble and remount the master cylinder in the reverse
order of removal and disassembly. Pay attention to the following
points:
!CAUTIONI
* Clean the master
cylinder
components
with
fresh
brake
fluid
before reassembly. Never use cleaning
solvent
or
gasoline
to
clean them.
* Do
not
wipe the
components
with a rag.
*
Apply
brake
fluid
to the
cylinder
bore and all the
component
to
be inserted
into
the bore.
III
Specification and Classification: DOT 4
• Tighten each bolt to the specified torque.
(Brake hose routing:
c::::T'1
0-21)
~
Brake hose
union
bolt
CD:
23 N·m (2.3 kgf-m,
16.5Ib-ft)
Rear master
cylinder
mounting
bolt~:
10 N·m (1.0 kgf-m, 7.0 Ib-ft)
Rear master
cylinder
rod lock-nut @:
18 N·m (1.8 kgf-m, 13.0 Ib-ft)
• Bleed air from the brake system. (c::::T'2-27)
INSPECTION AFTER REASSEMBLY
Rear brake (c::::T'2-26)
CHASSIS
8·69