Filter
Top Products
3·94
ENGINE
• Insert the clutch drive plates and driven plates one by one into
the clutch sleeve hub in the prescribed order.
NOTE:
Insert the outermost
NO.1
drive plate claws ® to the other slits
®
of
clutch housing as shown.
Direction of outside
..
DRIVE PLATE:
®
NO.1
Drive Plate 8 pcs [Green paint]
@
NO.2
Drive plate 2 pes [Brown paint]
DRIVE PLATE:
@ No.1 Driven plate (Thickness): 2.3 mm (0.091 in) 8-9 pes }
© No.2 Driven plate (Thickness): 2.0 mm (0.079 in) 0-1 pc Total 9 pcs
© No.1 Driven plate (Thickness): 2.6 mm (0.102 in) 0-1 pc
NOTE:
It is not necessary to use the
No.2
driven plate @ and the No. 3 driven plate © when replacing the driven
plates with the new ones. Because, they are factory setting parts.
• Install the clutch push rod
@)
into the countershaft.
• Install the clutch push piece @, the bearing @ and the thrust
washer ® to the countershaft.
NOTE:
Thrust washer
® is located between the pressure plate and the
bearing@.