Filter
Top Products
THROTTLE BODY REASSEMBLY
Reassemble the throttle body in the reverse order of disassem-
bly.
Pay attention to the following points:
• With the STV fully opened, install the STP sensor
CD.
NOTE:
* Align the secondary throttle shaft end ® with the groove @
of
the STP sensor.
* Apply SUZUKI SUPER GREASE to the secondary throttle
shaft end
®
if
necessary.
~
99000-25030: SUZUKI SUPER GREASE
"A"
(USA)
99000-25010: SUZUKI SUPER GREASE
"A"
(Others)
iT%l..
09930-11950:
Torx
wrench
~
STP sensor mounting screw: 3.5 N·m (0.35 kgf-m, 2.5 Ib-ft)
NOTE:
If
the STP sensor adjustment is necessary, refer to page 5-22
for STP sensor setting procedure.
• With the throttle valve fully opened, install the TP
sensor~.
iT%l..
09930-11950:
Torx
wrench
~
TP
sensor
mounting
screw:
3.5 N·m (0.35 kgf-m, 2.5 Ib-ft)
NOTE:
* Align the throttle shaft end © with the groove ©
of
the TP sen-
sor.
* Apply SUZUKI SUPER GREASE to the throttle shaft end © if
necessary.
TP sensorsetting procedure.
(L::7'4-18)
~
99000-25030: SUZUKI SUPER GREASE
"A"
(USA)
99000-25010: SUZUKI SUPER GREASE
"A"
(Others)
• Install the O-rings
CD
to each fuel injector.
• Apply thin coat of the engine oil to the new O-rings.
• Install the fuel injectors by pushing them straight to each throt-
tle body.
I
CAUTION
I
Replace
the
dust
seal
and
O-ring
with
the
new
ones.
Never
turn
the
injector
while
pushing
it.
FUEL
SYSTEM
AND
THROTTLE
BODY
5·19