Filter
Top Products
RELAYS
TURN SIGNAUSIDE-STAND RELAY
The turn signal/side-stand relay is composed of the turn signal
relay, side-stand relay and diode.
ELECTRICAL
SYSTEM
9·31
SIDE-STAND RELAY
"-------------,
DIODE
r
TURN
"-
- - - -
-,
LollI
:
SIGNAL
.....
,
,\
RELAY
:
..
~
8
ffi
,--
---,
---
--
--"
INSPECTION
Before removing the turn signal/side-stand relay, check the
operation of the turn signal light.
If the turn signal light does not illuminate, inspect the bulb, turn
signal switch and circuit connection.
If the bulb, turn signal switch and circuit connection are OK, the
turn signal relay may be faulty. In this case, replace the turn sig-
nal/side-stand relay with a new one.
NOTE:
* Make sure that the battery is fully charged.
* Refer to the page 9-16 for the side-stand relay
and
diode
inspection.
STARTER RELAY
c::::T9-14
FUEL PUMP RELAY
c::::TS-9
SWITCHES
@@©©®
®©
IGNITION SWITCH REMOVAL
• Disconnect the coupler.
• Remove the ignition switch mounting bolts with the special
tools.
ITUt!
09930-11920:
Torx
bit
JT40H
09930-11940: Bit
holder
ICAUTION I
When reusing the
ignition
switch bolt, clean thread
and
apply
the THREAD LOCK.
~99000-32050:
THREAD LOCK "1342" (USA)
~
99000-32110: THREAD LOCK SUPER "1322" (Others)