Filter
Top Products
NOTE:
Use the special
tool,
to prevent the rubber of the water proof
coupler from damage.
• Shift the transmission into neutral and turn ignition switch
"ON".
• Crank the engine a few seconds with the starter motor by
depressing starter button and check the ignition coil primary
peak voltage.
• Repeat the above inspection a few times and measure the
highest peak voltage.
~
Tester knob indication: voltage
(::-::-::)
_ Ignition coil primary peak voltage: 80 V and more
A WARNING
Do
not
touch
the tester probes and
spark
plugs
to pre-
vent an electric
shock
while testing.
If the peak voltage is lower than the standard range, check the
ignition coil/plug cap as follow.
ELECTRICAL
SYSTEM
9-21
IGNITION COIUPLUG CAP RESISTANCE
• Check the ignition coil/plug cap for resistance in both primary
and secondary coils. If the resistance is not within the stan-
dard range, replace the ignition coil/plug cap with a new one.
'Tuh 09900-25008: Multi
circuit
tester
set
~
Tester
knob
indication: Resistance
(0)
_ Ignition coil/plug cap resistance
Primary :
0.8 -
2.50
(CB
tap - 8 tap)
Secondary:
8
-18
kO (Plug cap - 8 tap)
-.-----------,