Filter
Top Products
3·10
ENGINE
• Remove the engine mounting bolts and gradually lower the
front side of the engine. Then, take off the drive chain from the
driveshaft.
• Remove the engine assembly.
ENGINE INSTALLATION
Install the engine in the reverse order of engine removal.
Pay attention to the following points:
NOTE:
Be careful not to damage the frame
and
engine when installing
the engine.
• Before installing the engine, install the spacer
CD.
• Before installing the engine, install the engine mounting thrust
adjusters
ell
and @.
• Gradually raise the rear side of the engine assembly, and
then put the drive chain on the driveshaft.
• Install all engine mounting bolts, spacers and tighten them
temporarily.
(c:::r3-12)
ICAUTION I
Be careful
not
to catch
the
wiring harness between the
frame and the engine.
• Tighten the engine mounting thrust adjusters to the specified
torque.
• Tighten the engine mounting thrust adjuster lock-nuts to the
specified torque with the special tool.
~
Engine
mounting
thrust
adjuster lock-nut:
45 N·m (4.5 kgf-m, 32.5Ib-ft)