Filter
Top Products
ENGINE 3-43
GENERATOR
INSPECTION (9-10)
REASSEMBLY
• When installing the generator stator set bolts, tighten them to
the specified torque.
Generator stator set bolt: 11 N·m (1.1 kgf-m, 8.0 lb-ft)
NOTE:
Be sure to install the grommet
1
to the generator cover.
WATER PUMP
7-11
GEARSHIFT SYSTEM
GEARSHIFT SHAFT/GEARSHIFT ARM DISASSEMBLY
• Remove the following parts from the gearshift shaft/gearshift
arm.
1 Washer 5 Plate return spring
2 Snap ring 6 Washer
3 Gearshift shaft return spring 7 Screw
4 Gearshift cam drive plate
GEARSHIFT SHAFT/GEARSHIFT ARM INSPECTION
• Inspect the gearshift shaft/gearshift arm for wear or bend.
• Inspect the return springs for damage or fatigue.
• Replace the arm or spring if there is anything unusual.
GEARSHIFT SHAFT/GEARSHIFT ARM REASSEMBLY
• Apply THREAD LOCK to the gearshift shaft screw.
99000-32050: THREAD LOCK “1342”
NOTE:
When installing the gearshift shaft return spring, position the
stopper
A
of gearshift arm between the shaft return spring ends
B
.