Filter
Top Products
3-56 ENGINE
• Install the driveshaft left bearing dust seal with the special
tool.
09913-70210: Bearing installer set (62)
• Put the driveshaft assembly 1 into the lower crankcase.
• Install the driveshaft right bearing assembly 2.
• Apply THREAD LOCK to the bolts and tighten them to the
specified torque.
99000-32050: THREAD LOCK “1342”
Driveshaft right bearing case bolt:
12 N·m (1.2 kgf-m, 8.7 lb-ft)
• Install the gearshift forks 3 as shown.
• Install the gearshift cam 4 with the bearing fitted.
• With engaging each fork end to the cam groove, insert the
fork shaft 5.
• Apply THREAD LOCK to the screws and tighten them to the
specified torque.
99000-32050: THREAD LOCK “1342”
Bearing retainer screw: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
• Install the dowel pin.
• Apply SUZUKI SUPER GREASE “A” to the O-ring and fit the
driveshaft left bearing case 6.
99000-25010: SUZUKI SUPER GREASE “A”
(or equivalent grease)
Replace the O-ring with a new one.