Filter
Top Products
6-6 EXHAUST SYSTEM
• Tighten the EXCVA mounting bolts to the specified torque.
EXCVA mounting bolt: 6.0 N·m (0.6 kgf-m, 4.5 lb-ft)
• Turn in the two cable adjusters fully.
• Connect the No.1 cable 1 (01H0CL) and No.2 cable 2
(01H0OP) to the EXCVA pulley.
No.1 cable: 01H0CL
No.2 cable: 01H0OP
• After connecting the No.1 cable 1, loosen the lock-nut 3 and
turn the adjuster 4 in or out until the thread length C
becomes the measured value before disconnecting the No.1
cable 1.
• Tighten the lock-nut 3.
• After connecting the No.2 cable 2, loosen the lock-nut 5 and
turn the adjuster 6 in or out until the thread length D
becomes the measured value before disconnecting the No.2
cable.
• Tighten the lock-nut 5.
• Connect the EXCVA lead wire couplers 7, 8.
EXCVA INSPECTION
4-91
The cable slots of EXCVA pulley must be located
adjustment position. (6-4)
If the EXCVA adjustment is necessary,refer to page
6-8 to -10 for EXCVA ADJUSTMENT setting procedure.