Filter
Top Products
8-92 CHASSIS
• Stake the joint pin by turning (approximately 7/8 turn) the
pressure bolt “A” 3 with the bar until the pin end diameter
becomes the specified dimension.
Pin end diameter specification D
• Adjust the drive chain, after connecting it. (2-20)
RK 5.45 – 5.85 mm (0.215 – 0.230 in)
* After joining of the chain has been completed, check
to make sure that the link is smooth and no abnormal
condition is found.
* Should any abnormal condition be found, reassem-
ble the chain link using the new joint parts.