Filter
Top Products
ENGINE 3-25
CRANKSHAFT
• Loosen the conrod bearing cap bolts by using a 10 mm,
12-point socket wrench, and tap the bearing cap bolts lightly
with a plastic hammer to remove the bearing cap.
• Remove the crankshaft and thrust bearings 1.
PISTON AND CONROD
• Push the conrod to cylinder head side and remove the piston
and conrod from the upper crankcase.
• Remove the piston pin circlip 1.
• Separate the piston and conrod by driving out the piston pin.
NOTE:
Scribe the cylinder number on the piston head.
Be careful not to damage the cylinder wall by the con-
rod.