Filter
Top Products
3-20 ENGINE
• Remove the shaft 4, bearing 5 and thrust washer 6.
• Remove the generator cover.
• Remove the dowel pins and gasket.
• Remove the starter idle gear No. 2 7 and shaft 8.
CAM CHAIN/CAM CHAIN TENSIONER/CAM CHAIN GUIDE
• While holding the generator rotor with the special tool, remove
the CKP sensor rotor/cam chain drive sprocket nut.
09930-44520: Rotor holder
• Remove the CKP sensor rotor/cam chain drive sprocket 1
and cam chain 2.
• Remove the cam chain tensioner 3 and cam chain guide
No. 1 4.