Filter
Top Products
ENGINE 3-81
GENERATOR ROTOR AND STARTER DRIVEN GEAR
• Degrease the tapered portion A of generator rotor and also
the crankshaft B. Use nonflammable cleaning solvent to wipe
off oily or greasy matter and make these surfaces completely
dry.
• Install the generator rotor onto the crankshaft.
• Install the rotor bolt.
• Hold the generator rotor with the special tool and tighten its
bolt to the specified torque.
09930-44520: Rotor holder
Generator rotor bolt: 120 N·m (12.0 kgf-m, 87.0 lb-ft)
CAM CHAIN/CAM CHAIN TENSIONER/CAM CHAIN GUIDE
• Install the cam chain.
• Apply a small quantity of THREAD LOCK to the cam chain
tensioner bolt and cam chain guide bolt.
• Install the cam chain tensioner 1.
• Install the cam chain guide No. 1 2.
99000-32050: THREAD LOCK “1342”
Cam chain tensioner bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
Cam chain guide No. 1 bolt: 23 N·m (2.3 kgf-m, 6.5 lb-ft)
• Install the CKP sensor rotor/cam chain drive sprocket onto the
crankshaft.
NOTE:
When installing the cam chain drive sprocket, align the wide
spline tooth
A
and
B
.
• Set the cam chain onto the teeth C.