Filter
Top Products
3-10 ENGINE
ENGINE INSTALLATION
Install the engine in the reverse order of engine removal.
Pay attention to the following points:
NOTE:
Be careful not to damage the frame and engine when installing
the engine.
• Before installing the engine, install the engine mounting thrust
adjusters 1 and 2.
• Gradually raise the rear side of the engine assembly, and
then put the drive chain on the driveshaft.
• Install all engine mounting bolts and tighten them temporarily.
(3-11)
• Tighten the engine mounting thrust adjusters to the specified
torque.
09940-14980: Engine mounting thrust adjuster
socket wrench
Engine mounting thrust adjuster:
23 N·m (2.3 kgf-m, 16.5 lb-ft)
• Tighten the engine mounting thrust adjuster lock-nuts to the
specified torque with the special tool.
09940-14980: Engine mounting thrust adjuster
socket wrench
Engine mounting thrust adjuster lock-nut:
45 N·m (4.5 kgf-m, 32.5 lb-ft)
• Tighten all engine mounting bolts and nuts to the specified
torque. (3-11)
NOTE:
The engine mounting nuts are self-locking. Once the nuts have
been removed, they are no longer of any use.
• Tighten the engine mounting pinch bolts to the specified
torque. (3-11)
Be careful not to catch the wiring harness between the
frame and the engine.