Filter
Top Products
6-10 EXHAUST SYSTEM
Measure the position sensor output voltage at fully open posi-
tion.
Position sensor output voltage
EXCV is fully open: 3.7 output voltage 4.5 (V)
(+ Yellow – - B/Br)
If the measured voltage is more than specification, adjust the
No.2 cable adjuster as follows:
• Set the EXCVA to adjustment position. (6-4)
• Turn out the No.2 cable adjuster 1.
• Repeat the above procedure until the output voltage comes
within the specified value.
Position sensor output voltage
EXCV is fully open: 3.7 output voltage 4.5 (V)
• After adjusting the EXCV cables, perform 2nd step to confirm
C46 is not indicated.
EXCV/EXHAUST PIPE, MUFFLER REMOVAL
• Remove the frame cover. (8-8)
• Remove the under cowling. (8-5)
• Lift and support the fuel tank. (5-3)
• Remove the EXCV cables 1, 2 from the EXCV pulley.
• Remove the EXCV cable bracket 3.
• Disconnect the HO
2 sensor lead wire coupler. (4-107)
• Remove the HO
2 sensor. (4-107)
• Remove the radiator mounting bolts 4.
• Move the radiator forward.
V
Adjusting the No.2 cable with the EXCV fully opened
can damage the EXCVA. Be sure to adjust the No.2
cable with the EXCV set in adjustment position.
Be careful not to bent the radiator fin.